opto isolator - 24V signal to drive led - Electrical Engineering

I have a PLC which gives 24V DC output. I would like to drive an external LED using 24V. Is this the correct way to drive an led? Which is the right method let me know any changes needed. simulate

21.5V instead of 24V on Wind and Status - Ruida controllers - LightBurn Software Forum

1 Channel Way Optocoupler Isolation Module PC817 EL817 3V-5V 12V 24V Photoelectric Isolator Rail Holder PLC Drive Motor Board - AliExpress

4Bit Optocoupler Isolator 5V to 24V Level Voltage Converter Board PLC Signal - Converter Module - Arduino, Robotics, Raspberry Pi, ESP8266, Learning DIY, Development board ICStation

transistors - 24V signal switching optccoupler - Electrical Engineering Stack Exchange

7 Watt LED Driver SMPS Circuit - Current Controlled - Homemade Circuit Projects

opto isolator - 24V signal to drive led - Electrical Engineering Stack Exchange

4Bit Optocoupler Isolator 5V to 24V Level Voltage Converter Board PLC Signal - Converter Module - Arduino, Robotics, Raspberry Pi, ESP8266, Learning DIY, Development board ICStation

SOLVED] Vary the HIGH – LOW limit from a digital signal in Arduino UNO. - General Electronics - Arduino Forum

1 way optocoupler isolation module photoelectric isolator signal isolation anti-interference 3-5V/12V/24V - AliExpress

Logic Level Shifter Design. If you have bumped into this article…, by Pinwheel Robotics

Control motor with Arduino via isolated 0-5 V DC signal - Project Guidance - Arduino Forum

Need help designing an isolated optocoupler circuit using an N-Channel MOSFET : r/AskElectronics