Correct Pin Matching using SPI ports on the MKR Zero? - Networking, Protocols, and Devices - Arduino Forum

Hi all, I would like to connect my MKR ZERO to a special microphone (Infineon's MEMS Microphone IM69D130: GitHub - Infineon/IM69D130-Microphone-Shield2Go: Examples for Infineon's MEMS microphone based evaluation board IM69D130 Microphone Shield2Go for Arduino. ). Both use I2S Bus. The MKR Zero uses the SPI ports for this. I am very new to Arduino and do not know a lot of pin matching tipps and tricks. Also most tutorials use Arduino UNO and not the MKR Zero. Can you guys help me? How is the co

MicroPython with esp8266 and esp32: flashing firmware and using PyCharm IDE – 3 – Renzo Mischianti

Arduino-Based Sensor Nodes

An ESP32 / Teensy 3.5 Super Clock

Ebyte LoRa E32 device for Arduino, esp32 or esp8266: specs and basic use – 1 – Renzo Mischianti

Meet the Seeeduino XIAO - Tiny but Powerful Arduino Alternative

Ebyte LoRa E32 device for Arduino, esp32 or esp8266: specs and basic use – 1 – Renzo Mischianti

Arduino-Based Sensor Nodes

Code – Page 2 – ITP Physical Computing

arduino uno - How to use multiple SPI slaves in MKR1000 if it doesn't have Slave Select (SS/CS) pin? - Arduino Stack Exchange

Overview, Arduino Ethernet + SD Card

Send emails with attachments: Arduino SAMD boards (WiFiNINA) – 3 – Renzo Mischianti

esp12 esp07 (esp8266): flash, pinout, specs and Arduino IDE configuration – 6 – Renzo Mischianti

SPI Example with Arduino Uno and MKR WiFi 1010