EPever 3210AN 12V/24V MPPT Battery Regulator Charge Controller

EPever 1210AN 12V/24V MPPT Battery Regulator Charger Controller with Max PV Input 100v for Solar home System Solar Charge Controller Brand: Temank Apllication: Solar home System, field monitoring, stations, etc Advanced MPPT technology
Solar Charge Controller Brand: Temank Apllication: Solar home System, field monitoring system, stations System, etc Advanced MPPT technology, with efficiency no less than 99.5% Ultra-fast tracking speed and guaranteed tracking efficiency Advanced MPPT control algorithm to minimize the maximum power point loss rate and loss time Wide MPP operating voltage range High quality components, perfecting system performance, with maximum conversion efficiency of 98% Accurate recognition and tracking of multiple-peaks maximum power point International famous brands of ST and IR's components of high quality and low failure rate are used, which can ensure the product’s service life Charging power and current limitation function Compatible with lead-acid and lithium-ion batteries Battery temperature compensation function Real-time energy statistics function Overheating power reduction function Multiple load work modes The communication port adopts professional protection chip, which can provide 5VDC power supply, and has over-current and short-circuit protection. With RS-485 communication bus interface and Modbus communication protocol, it is available to meet various communication requirements in different situations. Monitor and set the parameters via mobile phone APP or PC software Full-load operation without any drop in capacity within the range of working environment temperature Extensive electronic protection   ★If the temperature sensor is short-circuited or damaged, the controller will charge or discharge at the default temperature setting of 25 ºC.   Maximum Power Point Tracking Technology Due to the nonlinear characteristics of solar array, there is a maximum energy output point (Max Power Point) on its curve. Traditional controllers, with switch charging technology and PWM charging technology, can’t charge the battery at the maximum power point, so can’t harvest the maximum energy available from PV array, but the solar charge controller with Maximum Power Point Tracking (MPPT) Technology can lock on the point to harvest the maximum energy and deliver it to the battery. The MPPT algorithm of our company continuously compares and adjusts the operating points to attempt to locate the maximum power point of the array. The tracking process is fully automatic and does not need user adjustment. As the Figure 1-2, the curve is also the characteristic curve of the array, the MPPT technology will ‘boost’ the battery charge current through tracking the MPP. Assuming 100% conversion efficiency of the solar system, in that way, the following formula is established: Figure 1-2 is the maximum power point curve, the shaded area is charging range of traditional solar charge controller (PWM Charging Mode), it can obviously diagnose 3that the MPPT mode can improve the usage of the solar energy resource. According to our test, the MPPT controller can raise 20%-30% efficiency compared to the PWM controller. (Value may be fluctuant due to the influence of the ambient circumstance and energy loss.) In actual application, as shading from cloud, tree and snow, the panel maybe appear Multi-MPP, but in actually there is only one real Maximum Power Point. As the below Figure 1-3 shows:   If the program works improperly after appearing Multi-MPP, the system will not work on the real max power point, which may waste most solar energy resources and seriously affect the normal operation of the system. The typical MPPT algorithm, designed by our company, can track the real MPP quickly and accurately, improve the utilization rate of the array and avoid the waste of resources. Battery Charging Stage The controller has a 3 stages battery charging algorithm (Bulk Charging, Constant Charging and Float Charging) for rapid, efficient, and safe battery charging. A) Bulk Charging In this stage, the battery voltage has not yet reached constant voltage (Equalize or Boost Voltage), the controller operates in constant current mode, delivering its maximum current to the batteries (MPPT Charging). B) Constant Charging When the battery voltage reaches the constant voltage setpoint, the controller will start to operate in constant charging mode, this process is no longer MPPT charging, and in the meantime the charging current will drop gradually, the process is not the MPPT charging. The Constant Charging has 2 stages, equalize and boost. These two stages are not carried out constantly in a full charge process to avoid too much gas precipitation or overheating of battery. There is detail information about 3210AN 12V/24V MPPT Battery Regulator Charger Controller

EPEVER MPPT Solar Charge Controller 40A 12V/24V Power Regulator Max PV 100V

EPEVER 30A Solar Charge Controller MPPT 12V / 24V Auto Max.PV 100V Input Negative Ground Solar Panel Charge Regulator with MT50 Remote Meter Temperature Sensor RTS & PC Communication Cable

Battery Temperature Sensor Epever Monitor Adapter RS485/USB Communication Cable. when the internal temperature reach 81℃, the power reduction mode

40A 30A MPPT Solar Charger Controller 100V PV Epever Battery Regulator 12V/24V

MPPT Solar Charge Controller Tracer 3210AN 30A WiFi Adapter 12V 24V Auto Switch LCD Panel Battery Regulator Max 520W - AliExpress

★ Build-up >> EPever 40A MPPT charge controller fits for 12V/24V Battery DC automatically identifying system. Charge/Discharge current of 40A. Max. PV

EPEVER MPPT Solar Charge Controller 40A Max PV 100V, 12V/520W, 24V/1040W, Common Negative Grounding, Work for Lead-Acid Sealed /Gel(AGM)/Flooded and

Battery Temperature Sensor Epever Monitor Adapter RS485/USB Communication Cable. when the internal temperature reach 81℃, the power reduction mode

40A 30A MPPT Solar Charger Controller 100V PV Epever Battery Regulator 12V/24V

EPEVER 40A MPPT Solar Charge Controller 12V 24V Auto Max Input 100V Charger Controller Common Negative Grounded Solar Panel Regulator for Lead-Acid Lithium AGM Battery (Tracer4210AN) : Patio, Lawn

30A Epever MPPT Auto Max DC-100V Input Solar Charge Controller 12V/24V – Inverter Charger China Inc.

Epever Tracer 3210an Solar Regulator 12V/24VDC Auto MPPT 30A Max Input 100V Solar Charge Controller for Solar Panel Solar Energy System - China MPPT Charge Controller, Epever MPPT

EPEVER MPPT Solar Charge Controller 30A Tracer3210AN(Upgraded version), 12V 24V Auto Work, Max PV 100V, ,Max PV input power 390W for 12V Battery or

EPEVER MPPT Charge Controller 30A 12V 24V Auto Max PV 100V Solar Panel Generator Common Negative Ground Regulator Tracer3210AN with LCD Display for

EPEVER MPPT charge controller 30Amp Tracer3210AN + Remote Meter MT50 + Temp sensor cable RTS300R47K3.81A . 12V/24V Auto identifying system voltage.

EPEVER MPPT Solar Charge Controller 30A 12V 24V Auto Tracer3210AN + Remote Meter MT50 + RTS Common Negative Ground Solar Panel Regulator for Lead-Acid

2018 New Released TracerAN 30A MPPT Solar Charge Controller Using innovative MPPT technology with high tracking efficiency up to 99%, the charge

30A MPPT Solar Charge Controller 2018 100V PV Input Support Lithium Battery Charging Backlight LCD Negative Ground 12V 24V Auto 780W Solar Panel

EPEVER MPPT Laderegler 30A Tracer3210AN Charge Controller Auto Work 12V/24V LCD Display Commen Negative Erdung- Tracer3210AN

30A Epever MPPT Auto Max DC-100V Input Solar Charge Controller 12V/24V – Inverter Charger China Inc.

EPEVER 10A 20A 30A 40A 12V 24V Auto MPPT Solar Controller With LCD Display Solar Regulator 12V 24V Battery Auto